Difference between revisions of "Nouveau-Maxwell"
From QWiki
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | Don't do this if you don't understand what you are doing. Without a mounted fan on the card connected to the motherboard or water-cooling your 980ti will be very very hot! | + | Don't do this if you don't understand what you are doing. Without a mounted fan on the card connected to the motherboard or water-cooling your 980ti will be very very hot! |
In | In | ||
| Line 22: | Line 22: | ||
in /lib/modprobe.d/ or /etc/modprobe.d/ put this in the nouv.conf file: | in /lib/modprobe.d/ or /etc/modprobe.d/ put this in the nouv.conf file: | ||
| − | options nouveau config=NvClkMode= | + | options nouveau config=NvClkMode=15,NvMemExec=1,NvBoost=2 |
| − | + | Add this stuff to xorg.conf (or else.. fps drops!) | |
| + | Option "HWCursor" "on" | ||
| + | Option "GLXVBlank" "off" | ||
| + | Option "PageFlip" "off" | ||
| + | Option "DRI" "3" | ||
Latest revision as of 20:28, 3 September 2020
Don't do this if you don't understand what you are doing. Without a mounted fan on the card connected to the motherboard or water-cooling your 980ti will be very very hot!
In
linux/drivers/gpu/drm/nouveau/nvkm/engine/device/base.c
At the section
nv120_chipset = {
.name = "GM200",
[..]
Under
.bus = gf100_bus_new,
Add
.clk = gk104_clk_new,
Replace
.pmu = gm200_pmu_new,
With
.pmu = gm107_pmu_new,
.. recompile the kernel (that's out of the scope of this document)
in /lib/modprobe.d/ or /etc/modprobe.d/ put this in the nouv.conf file:
options nouveau config=NvClkMode=15,NvMemExec=1,NvBoost=2
Add this stuff to xorg.conf (or else.. fps drops!)
Option "HWCursor" "on" Option "GLXVBlank" "off" Option "PageFlip" "off" Option "DRI" "3"